Collection: Custom UV DTF

APPLICATION INSTRUCTIONS:

1.Use squeegee to scrap front and back of design (helps make sure the transfer paper layer is sticking to the design well)

2.Peel design transfer off of backing.

3.Place the transfer on the cup ensuring design is straight and positioned correctly.

**(The adhesive is very strong. Once the transfer touches the glass its impossible to take off)

4. Press the transfer down, working from the center outwards, pushing out any bubbles.

5. Rub all over the design with your squeegee apply HEAVY pressure.  The more rubbing the better.

5. Peel clear film off SLOWLY and you're done! As extra step i like to use the felt side of the squeegee to rub down one more time

CARE INSTRUCTIONS:

Hand wash only.  We do not advise to put in dishwasher or microwave. Do not leave in extreme temp areas (leaving in hot car too long could break down adhesive and cause peeling). Suggested to apply to flat smooth surfaces only (I personally tested one on a texture cooler and it only lasted a few days)

We are not responsible for application mishaps.

*Please note:  Not all brands of glass cups have the exact same measurements. They can differ by a couple of millimeters.